8
Item
Unit
Mono Bloc Unit
Starting Current
A
13.0
Running Current
A
Cooling: 13.0
Heating: 9.9
Cooling: -
Heating: 10.8
Maximum Current For Mono Bloc Unit
A
22.9
Power Factor
%
Cooling: 96
Heating: 95
Cooling: -
Heating: 95
Power factor means total figure of compressor and outdoor fan motor.
Number of core
-
Power Cord
Length m
(ft)
-
Thermostat
Electronic
Control
Protection Device
Electronic Control
Item
Unit
Water System
Performance Test Condition
EN 14511
Outdoor Ambient
°C
Cooling: 16 ~ 43
Heating: -20 ~ 35
Operation Range
Water Outlet
°C
Cooling: 5 ~ 20
Heating: 25 ~ 55
Internal Pressure Differential
kPa
Cooling: 36.5
Heating: 57.5
Inlet
mm (inch)
30 (1-3/16)
Water Pipe Diameter
Outlet
mm (inch)
30 (1-3/16)
Water Drain Hose Inner Diameter
mm (inch)
15.00 (19/32)
Motor Type
DC Motor
No. of Speed
7 (software selection)
Pump
Input Power
W
84
Type
Brazed
Plate
No. of Plates
48
Size (H × W × L)
mm
82 × 93 × 325
Hot Water Coil
Water Flow Rate
l/min (m
3
/h)
Cooling: 20.0 (1.2)
Heating: 25.8 (1.6)
Pressure Relief Valve Water Circuit
kPa
Open: 300, Close: 265 and below
Flow Switch
Magnetic Lead Switch
Protection Device
A
Residual Current Circuit Breaker (40)
Volume I
6
Expansion Vessel
MWP bar
3
Capacity of Integrated Electric Heater
kW
3.00
Note:
Cooling capacities are based on outdoor air temperature of 35°C Dry Bulb with controlled water inlet temperature
of 12°C and water outlet temperature of 7°C.
Heating capacities are based on outdoor air temperature of 7°C Dry Bulb (44.6°F Dry Bulb), 6°C Wet Bulb
(42.8°F Wet Bulb) with controlled water inlet temperature of 30°C and water outlet temperature of 35°C.
Specification are subjected to change without prior notice for further improvement.
