Charging the Wireless Monitor
Charge the Wireless Monitor for at least 30 minutes before pairing it to the Base Unit for the first time
*1
(page 10). After pairing, replace the Wireless Monitor and complete charging.
*1 This time is a guide for the time required when the temperature is 20 °C. When the surrounding
temperature is low, the time required for charging may increase.
1
Insert the battery pack.
R
Open the cover (
A
), insert the battery pack (
B
), and then close the battery cover (
A
).
Battery cover
A
B
2
Plug the connector into the relay box firmly (
C
), and then plug the AC adaptor into a power outlet
(100-240 V AC, 50/60 Hz) (
D
).
Pin
Charge contacts
(metal parts)
Charge indicator
AC adaptor
F
E
D
Relay box
C
3
Place the Wireless Monitor on the lower part of the Charger (
E
), and then firmly push it into the
Charger until it clicks into place (
F
). Check that the charge indicator lights up.
R
While charging: the charge indicator lights up.
When charging is completed: the charge indicator turns off.
(It takes about 6 hours to complete charging.)
R
When the signal display for the Wireless Monitor is
(out of range), the charging time increases.
R
The Wireless Monitor can be left on the Charger without causing it to overcharge.
R
When the battery pack is completely out of power, it may take some time until the charge indicator
lights up (about 5 minutes) when charging the Wireless Monitor. This is not a malfunction.
R
When removing the Wireless Monitor from the Charger, remove the upper part of the Wireless
Monitor first.
Note:
R
In order to maintain battery pack performance, remove the battery pack when the Wireless Monitor
is not in use for long periods of time.
9
Getting Started
Summary of Contents for VL-DM200BX
Page 14: ...14 Notes ...
Page 15: ...15 Notes ...
