Panasonic VL-CM851A, Operating Instructions Manual

Page: 23 / 52

Monitoring the outside
You can monitor the sounds and images from outside taken by the Wireless Camera.
R The sound from your end will not be heard at the Wireless Camera.
You can perform the following operations during monitoring:
R Switching between Wide/Zoom (page 23)
R Recording images (page 24)
R Adjusting brightness (display)/Audio output volume/Audio input volume (page 23)
MENU
PRESS TALK
1
Press M N (Monitor button).
R The outside image will be shown on the display, and you will hear the sound from outside.
R To speak to the other party at the Wireless Camera, press M PRESS TALK N .
You can speak to the other party by pressing and holding M PRESS TALK N .
R appears on the display.
R You cannot hear the sound from the other party when M PRESS TALK N is pressed.
You can hear the sound from other party by releasing M PRESS TALK N .
R disappears from the display.
R The sound from your end will not be heard at the Wireless Camera.
2
To end operations, press M N (Monitor button).
Note:
R Monitoring lasts for about 20 seconds after M N (Monitor button) is pressed.
However, if operations are performed during monitoring, monitoring can be extended to a maximum of
3 minutes.
R At night or at other times when the area around the Wireless Camera becomes dark, the following
occur:
– The image quality is reduced.
– Images are automatically brightened to make it easier to see the face of the other party. Although
images may appear to be washed out, this is not a malfunction.
Adjusting brightness (display)/Audio output volume/Audio input volume
1
Press M MENU N while monitoring.
2
Press MDN or MCN to select the desired item (such as brightness).
3
Press MFN or MEN to adjust it.
Manipulating displayed images with Wide/Zoom and Pan/Tilt
During monitoring, the display can be temporarily switched between Wide/Zoom, and the Zoom position
can be changed with pan/tilt operations.
23
How to use