66
Problem
Actions
Screen
Chaotic image, noisy
Set “P-NR” in the Picture Menu (to remove noise). (p. 26)
●
Check nearby electrical products
●
(car, motorcycle, fluorescent lamp).
No image can be displayed
Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
●
(p. 26)
Blurry or distorted image
(no sound or low volume)
Reset channels. (p. 30 - 33)
●
Unusual image is displayed
Turn the TV Off with Mains power On / Off switch, then turn it On
●
again.
If the problem persists, perform “Shipping Condition” (p. 42).
●
Sound
No sound is produced
Is “Sound mute” active? (p. 9)
●
Is the volume set to the minimum?
●
Sound level is low
or sound is distorted
Sound signal reception may be deteriorated.
●
Set “MPX” (p. 27) in the Sound Menu to “Off”.
●
(Analogue only)
Digital Channel
Due to the digital reception technologies involved, quality of the digital signals may be relatively low in
●
some cases, despite good reception of analogue channels.
Interference or
frozen / disappearing image in
DVB mode
Check “Signal Condition” (p. 37).
●
If “Signal Quality” or “Signal Strength” are displayed in red, the
signal is weak.
Check aerial, cable or dish. If problem persists, consult your local
●
dealer.
Weather conditions will affect signal reception (heavy rain, snow,
●
etc.), in particular in poor reception areas. Even during good weather
the high pressure can cause poor reception of some channels.
Turn the TV off with the Mains power On / Off switch, then turn it On
●
again.
Some channels
cannot be tuned
Check the aerial, cable or dish.
●
Consult your local dealer.
●
DVB-S Auto Setup cannot be
done completely
Check connections and dish alignment. (p. 10)
●
If the problem persists, consult your local dealer.
●
HDMI
Sound is unusual
Set the sound setting of the connected equipment to
●
“2ch L.PCM”.
Check the “HDMI1 / 3 Input” setting in the Sound Menu. (p. 27)
●
If digital sound connection has a problem, select analogue sound
●
connection. (p. 63)
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Check the HDMI cable is connected properly. (p. 58)
●
Turn the TV and equipment Off, then turn them On again.
●
Check an input signal from the equipment. (p. 64)
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Other
The TV does not switch On
Check the mains lead is plugged into the socket outlet.
●
The TV goes into
“Standby mode”
Off Timer function is activated.
●
The TV enters “Standby mode” about 30 mins. after analogue
●
broadcasting ends.
The remote control does not work
or is intermittent
Are the batteries installed correctly? (p. 6)
●
Has the TV been switched On?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the front of the TV (within a
●
30 degree angle of the front of the TV).
Situate the TV away from sunshine or other sources of bright light
●
not to shine on the TV’s remote control signal receiver.
An error message appears
Follow the message’s instructions.
●
If the problem persists, contact the authorized Service Centre.
●
FAQs
