Panasonic Viera TC-L47E5, Owner'S Manual

Page: 15 / 74

Getting started
15
•
First T
ime
Setup
•
Identifying Controls
First Time Setup
POWER
OK
or
Turn the TV On with the POWER button
(TV) (Remote)
or
POWER
Configure your viewing mode
Select your language
Language / Idioma / Langue
Step 1 of 7 / Paso 1 de 7 / Étape 1 de 7
OK
Select
Selección
Sélection
English Español Français
Select your language
Seleccione su idioma
Sélection de la langue
OK
select
OK
Select your country
Step 2 of 7
RETURN
OK
Select
Country
Select the country where this TV is being used.
U.S.A. Canada Other
OK
select
OK
Select your viewing mode
(Be sure to select “Home use”)
Step 3 of 7
RETURN
OK
Select
Set viewing mode
Home use Store Demonstration
Select your viewing environment
OK
select
OK
●
Please confirm your selection (Home Use) before pressing OK button.
■
If you select “ Store Demonstration” by mistake in ,
confirmation screen will be displayed.
No
You are selecting the store demonstration mode.
If you select “Yes”, the picture mode will regularly reset
to “Vivid” and a Picture Refresh message will be displayed on the
screen.
Yes OK
select
OK
●
Select “No” and return to previous screen .
●
If you select “Yes”, screen enters the store demonstration mode.
To display the “Set viewing mode” screen again as shown above and select
“Home use”, do one of the following:
• Press and hold down the rear POWER button for at least five seconds.
• Unplug power cord for 30 seconds and plug in again.
Note
●
If you use any other step other than then turn the TV off, or if you used the EXIT
button to quit before completing the settings, the next time you turn the TV on, “First
time setup” will not be automatically displayed.
• The settings up to that point are saved.
• You can start “First time setup”. (p. 53)
●
Language, ANT/Cable setup, Input labels, Clock can also be changed from the
Settings Menu. (p. 52)
The first time setup screen is displayed only when the TV is turned on for the first time after the power cord
is inserted into a wall outlet and when “Auto power on” (p. 53) is set to “No”.
TC-L32_37_42_47E5_EN.indb 15 TC-L32_37_42_47E5_EN.indb 15 4/23/2012 11:27:44 AM 4/23/2012 11:27:44 AM