4 - 6
Troubleshooting > Problem Guide
Pressing the REC button
will not start recording.
Recording starts but stops
immediately.
Recording starts but stops
immediately.
(For VDR-M30PP)
LCD screen is hard to see.
Black dots or red, blue or
green dots always lit appear
on LCD screen or in
Viewfinder.
Focus is not correct.
Recognition of disc is not
complete.
Pressing the playback
button will not start
playback.
Symptom
Cause and Correction
Is input image copy-guarded?
The specifications state that VDR-M30 cannot record a copy-guarded image.
Does dirt or fingerprint adhere to
disc, or is disc scratched?
Clean the disc. If there is still no
improvement, replace the disc.
Is some other AV device directly connected to the AV/S input/output jack of
VDR-M30?
If the AV device is connected via several other devices, such as AV selector, the
video signal may not be transmitted correctly. In such a case, reduce the number
of devices through which the video signal is transmitted, or connect AV device
directly.
Are you attempting to record image from video game or PC?
Depending on video game or PC, image cannot be recorded on VDR-M30.
Has brightness of LCD screen been adjusted?
Stop recording and adjust the brightness.
Is VDR-M30 being used outdoors?
Use the viewfinder. When using LCD monitor, adjust angle so that LCD screen
is not exposed to direct sunlight.
The panels used for LCD monitor and viewfinder of VDR-M30 are produced
using highly precise technology. However, 0.01% or less of total pixels may not
light (black dots) or may remain lit (red, blue, green dots). (The effective amount
of pixels on LCD panel is 99.99% or more.) This shows the limitations of the
current technology, and does not indicate a fault that will interfere with the
operation of LCD panel or operation of VDR-M30.
Is it difficult to use auto-focus with the subject?
Focus manually.
Does "MF" appear?
The VDR-M30 is set to manual focus. Focus the subject manually, or release
manual focus.
Is the diopter control of viewfinder correctly adjusted?
Adjust the diopter control.
In cases other than the above, set the power switch to "POWER OFF", and then
reset it to the original position.
Does dirt or fingerprint adhere to disc, or is disc scratched?
Clean the disc.
Was the image recorded on a device other than VDR-M30?
Playback of image recorded on devices other than VDR-M30 may be impossible.
Has scene been edited on a device other than VDR-M30?
If a scene that was recorded on VDR-M30 is edited on a device other than VDR-
M30, playback may not be possible on VDR-M30.
During playback
Use soft cloth to clean
from inner to outer
circumference in
axial direction.
[Never use solvent.]
Disc cleaning method:
During recording
