II - 28
<Checking all the indoor unit addresses from an arbitrary wired remote controller>
It is possible to check the number and location of indoor units connected to the same refrigerant tubing system (with
the same system address).
In this method all the indoor units on the system are stopped.
Press the time setting
button and
button simultaneously for longer than 4 seconds.
On the remote controller “System
” and “Item code
” are displayed.
Using the
or
buttons select the system number.
Display the desired “System
” (System
→
→
…)
Press the
button to de
fi
ne the selected system address.
On the remote controller display “Unit No. - ” (
→
→
…).
Press the
button.
Each time the
button is pressed, the indoor unit No (Unit No
-
→
-
→
-
…) tubing system is
displayed and the fan only of the selected indoor unit operates.
• Look for the indoor unit whose fan is operating. This indoor unit is the indoor unit selected on the remote
controller.
* During “ ” if the time setting
or
buttons are pressed, then
pressed, the address will change, so
care is needed.
To select an address on a separate system, press the
button, and it returns to “ ”.
Repeat
operations - .
Press the
button.
The remote controller returns to the normal display, and all the indoor units are stopped.
W̲02̲22-31.indd 28
W̲02̲22-31.indd 28
2012/05/22 11:23:17
2012/05/22 11:23:17