12
Assembly Procedure
For safety reasons, overturn/fall prevention measure must be always taken
The unit may overturn in the event of an earthquake etc. Therefore, overturn/fall prevention measure must be
always taken.
* The details in this section indicate how to reduce any damage or injury caused by this unit overturning or
falling due to an earthquake or other reason. However, there is no guarantee that the overturn/fall prevention
accessories will be effective in all earthquake or other situations.
4. Plasma Display Overturn-Prevention
| Anchor the plasma display to both the base and the wall surface.
ヂ
Anchoring to the base
Attach the overturn-prevention belts
ヂ
(2 belts) to the screw holes at both sides of the rear of the pedestal
using screws
ッ
(2 screws) and overturn-prevention clamps
デ
(2 clamps), and use the wood screws
ツ
(2
screws) to anchor to the base.
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw
ッ
tightening torque: 1.2 to 1.5 N•m)
ッ
Anchoring to the wall
Pass sturdy string, wire, or other item
through the hooks attached in Step 2.
ッ
and anchor the string etc. to a secure wall
or pillar.
* Use a commercially available string,
wire or other item.
フック
Screw
ッ
Screw
ッ
Overturn-prevention belt
ヂ
Overturn-prevention
clamp
デ
Overturn-prevention belt
ヂ
Front face
Wood screw
ツ
Wood screw
ツ
Locate the wood
screw at the center of
the material width.
Surface of wall
Overturn-prevention
clamp
デ
Hook
ヅ
English
Summary of Contents for TY-ST65P20
