Panasonic TX-P42GW30, Service Manual

Page: 26 / 118

26
8.18. Remove the Contact metals
1. Remove the Cabinet assy. (See section 8.17.)
2. Remove the Tape from the Contact metals.
3. Remove the screws (
×
8 ).
4. Remove the Contact metal side (L, R).
5. Remove the screws (
×
6 ).
6. Remove the Contact metal top.
7. Remove the screws (
×
15 ).
8. Remove the Contact metal bottom A.
8.19. Remove the K-Board
1. Remove the Contact metal bottom B. (See section 8.16.)
2. Remove the screw (
×
1 ).
3. Remove the claw (
×
1 ).
4. Disconnect the connector (K1) and remove the K-Board
from the LED Panel.
8.20. Replace the Plasma panel
Caution:
Place the Plasma panel on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
A new plasma panel itself without Contact metals is fragile.
To avoid the damage to new plasma panel, carry a new
plasma panel taking hold of the Contact metals.
1. Place a carton box packed a new plasma panel on the flat
surface of the work bench.
2. Open a box and without taking a new plasma panel.
3. Attach the cabinet assy and each P.C.Board and so on, to
the new plasma panel.