ALIGNMENT SETTINGS
(The figures below are nominal and used for representative purposes only.)
1. Set the Bass to maximum position, set the Treble to minimum position, set the Volume to minimum then press the
down button (
-/v
) on the customer controls at the front of the TV and at the same time press the
INDEX
button on the
remote control, this will place the TV into the Service Mode 1.
2. Press the
RED
/
GREEN
buttons to step up / down through the functions.
3. Press the
YELLOW
/
BLUE
buttons to alter the function values.
4. Press the
OK
button after each adjustment has been made to store the required values.
5. To exit the Service Mode, press the "
N
" button.
Alignment Function
Setting indication
Note
: All setting values are approximate
Settings / Special features
EAROM copy
TV/EXT
---
FLASH program copy
EXT -> TV
---
Horizontal Position
H-Pos
-4
Optimum setting.
Vertical Position
V-Pos
0
Optimum setting.
Horizontal Amplitude
H-Amp
93
Optimum setting.
Vert. Amplitude
V-Amp
-15
Optimum setting.
EW-amplitude
EW-Amp 1
- 30
Optimum setting.
Lower Corner
Lower Corner
11
Optimum setting.
Trapezium-comp
Trapez 1
4
Optimum setting.
Upper Corner
Upper Corner
11
Optimum setting.
Vertical Linearity
V-Lin
39
Optimum setting.
Vertical Symmetry
V-Sym
-6
Optimum setting.
Angle
Angle
0
Optimum setting.
Bow
Bow
0
Optimum setting.
DVCO
DVCO
63
Receive a PAL Colour Bar Pattern. For
DVCO alignment press "
Blue
" button, wait
until the figure colour is changed from red
to black colour.
Highlight
Lowlight
High 0374 0318 0335
Low
0207 0331 0256
Optimum setting.
Sub-Brightness
Sub-Brightness
-10
Optimum setting.
6