Important Note :
The layout of the mains plug used
may differ from this illustration.
3
WARNINGS AND PRECAUTIONS
D
This T.V. is designed to operate on A.C. 220 --- 240V, 50Hz
and is capable of receiving the PAL I transmission
standard.
D
Do not expose this TV set to rain or excessive moisture.
D
WARNING: HIGH VOLTAGE !
Do not remove the rear cover, there are no user
serviceable parts inside.
D
Avoid exposing the TV set to direct sunlight or other
sources of heat.
D
Remove the mains plug from the wall socket when the TV
set is not to be used for a prolonged period of time. Do not
pull the power cable to remove the mains plug from the
socket, always remove it by the plug.
D
CABINET AND PICTURE TUBE CARE
Remove the mains plug from the wall socket. The cabinet
and picture tube can be cleaned with a soft cloth
moistened with mild detergent and water. Do not use
solutions containing benzol or petroleum. TV sets can
produce static electricity, care must be taken whenever
touching the TV screen.
D
Adequate ventilation is essential to prevent failure of
electrical components. We recommend that a gap of at
least 5cm is left all around this TV even when it is placed
inside a cabinet or between shelves.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING CAREFULLY
This appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. If
the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI mark
on the body of the fuse.
If the fitted plug has a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained.
Replacement fuse covers can be purchased through your local Panasonic dealer.
The plug fitted to this appliance incorporates a mains filter circuit. If this is removed or
replaced with a non---filtered mains plug this television will no longer meet the
European standards for Electromagnetic Compatibility (EMC). If the fitted plug is
unsuitable for the socket outlet in your home an appropriate adapter should be used.
Nonetheless, if the fitted plug is replaced, the fuse should be taken out and the cut---off
plug disposed of safely. There is danger of severe electrical shock if the cut off plug is
inserted into any 13amp. socket.
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
How to replace the fuse
:
Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit
securely into the mains plug.
IMPORTANT :---
The wires in the mains lead of this appliance are coloured in accordance with the following code :---
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your plug,
proceed as follows :---
1.
The
BLUE
wire must be connected to the terminal marked ‘N’ or coloured black.
2.
The
BROWN
wire must be connected to the terminal marked ‘L’ or coloured red.
IMPORTANT NOTE :
Under no circumstances should either of these wires be connected to the Earth terminal of the three pin plug,
marked with the letter ‘E’ or the earth symbol (
).
