![background image](http://html.mh-extra.com/html/panasonic/toughbook-cf-w4hwezzbm/toughbook-cf-w4hwezzbm_service-manual_1510612042.webp)
6.3. Reassembly instructions
6.3.1. Attention when CF-W4G series is repaired
·
Please execute writing BIOS ID when you exchange the Main Board.
·
Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.
6.3.2. Assembly knowhow of part LCD
LCD Rubber (Upper)
LCD Side Rubber
LCD Back Rubber (Lower)
LCD Front Case
LCD Front Case
LCD Rubber (Upper
LCD parallel after putting
big
small
LCD Rubber, LCD side Rubber and LCD backing Rubber’s putting
0
1mm
1
2mm
1
2mm
LCD Cable processing
Clamping processing of LCD Cable, LCD Connector connection and putting of PET Tape of cable
The LCD Insulation Sheet is peeled off and after processes as shown in the figure below,
Put the Insulation Sheet.
LCD Frame Clamp
A red line of the cable is matched to the LCD Frame externals.
Connector
PET Tape
LCD Insulation Sheet
Insulation seat of edge match
0
1mm
Connector of externals match
There must not be beginning to see from externals.
Conductive Cloth
(LCD Label)
Putting of The Conductive Cloth
The Conductive Cloth is put and after putting, a both side tape is put.
Process the part in the signal line of the LCD Cable in the Conductive Cloth.
Put the Conductive Cloth on the connector surely.
LCD Insulation Seat
Connector
Both Side Tape
LCD Cable
42
Summary of Contents for Toughbook CF-W4HWEZZBM
