10
Getting Started
7
Turn your computer on
Slide the power switch toward the rear of the computer and hold it for approximately
one second until the power indicator turns on before releasing it.
Power Switch
5
CAUTION
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
2
1
Connect your computer to a power outlet
CAUTION
Handling the AC adapter
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adapter with your computer. Using an AC adapter
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
Be sure the AC adapter is connected until completing Step
9
on page 12.
2
1
3
NOTE
The power saving function is factory set, so if there is no input from the keyboard,
touch pad, or external mouse for two minutes, the LCD is powered off (ECO
mode
"Computing on the Road" )*.
The LCD will resume operation when the touch pad or the external mouse is used
or a key is pressed.
The computer may enter the ECO mode while Windows is setting up or even when
an application software is being installed. In this case, because it is conceivable
that a selection dialog box will be shown, for resuming from the ECO mode, do not
press
Space
or
Enter
which may trigger a selection, instead, press a key
unrelated to the direct triggering of a selection, like the key.
* This excludes a pointing device connected to the USB port, e.g., a USB mouse.
The power saving mode ([Power Schemes] in [Control Panel] - [Power Management]) is
factory set, so if there is no input from the keyboard, touch pad, or external mouse (when one
is connected) for a certain interval of time, the power to the LCD and hard disk is shut down.
The LCD will resume operation when the touch pad is used, or a key or external
mouse is pressed.
The power to the LCD may be turned off while Windows is setting up or even when
an application software is being installed. In this case, because it is conceivable that a
selection dialog box will be shown, do not press the
Space
or
Enter
key to
attempt to resume from this condition as doing so may trigger a selection, but
instead, press a key unrelated to the direct triggering of a selection, like the
key.
* With Windows 98, "Suspend" is called "Standby".
Power Indica-
tor
6
Open the display
To open the display, slide the latch located at the front and lift open the display.
Windows 95
Windows 98
Ctrl
Ctrl
First-time Operation
Summary of Contents for Toughbook CF-47 Series
Page 30: ...30 Appendix...
Page 31: ...31 Appendix...
