45
English
Settings to connect to a LAN
[Important]
The network environment when controlling via LAN
is required to be physically isolated from the outside
network or not illegally connected / controlled by
unknown equipment with the Firewall.
Set the TV’s IP address and subnet mask to match the
settings of your LAN.
These settings can be made on either the TV or a
computer connected to the TV.
The settings depend on the configuration of your LAN.
For instructions on connection, consult your network
administrator.
To set on the TV
Set [SERIAL IN/LAN select] of [Network settings] on the
[Setup] menu to [LAN], and then set the [LAN setup]
options. (see page 37)
After setting each item, select [Set] and press
<ENTER>.
■
Network information
Displays LAN setting information. (see page 37)
Command-based control
You can control the TV using serial commands (see
page 21) via terminal software and other appropriate
applications.
Read the manual for the terminal software for detailed
instructions.
Supported commands
Commands used in the serial control are supported.
(see page 21)
●
Default user name and password are as follows:
User name: dispadmin
Password: @Panasonic
If you change user name and password, please use the
command below by serial line.
Command Parameter Control details
SSU:UNM
*...*
LAN control user name
(Max 16 Parameters)
Range of parameters:
[space] 0 1 2 3 4 5 6 7 8 9 A B C
D E F G H I J K L M N O P Q R S
T U V W X Y Z _ a b c d e f g h i j
k l m n o p q r s t u v w x y z - @
SSU:UPW
*...*
LAN control password
(Max 16 Parameters)
Range of parameters:
[space] 0 1 2 3 4 5 6 7 8 9 A B C
D E F G H I J K L M N O P Q R S
T U V W X Y Z _ a b c d e f g h i j
k l m n o p q r s t u v w x y z - @
1
Connect the computer to the TV.
1.
Specify the IP address and data port number
(10101) and connect the computer to the TV.
When connection has been established
successfully, [Login:] is returned as response.
2.
Send the user name.
●
Send [user name] + [ ].
●
If the user name is not set, send [ ].
●
When the transmission is successful, [
Password:] is returned as response.
3.
Send the password.
●
Send [password] + [ ].
●
If the password is not set, send [ ].
●
When the transmission is successful, [OK ]
is returned as response.
2
Send commands to control the TV.
The commands used are the same as those for
RS-232C. Refer to the communication procedure
(see page 21) for operation.
Usable commands are provided in the serial
command table (see page 21).
3
Disconnect the connection with the
TV and quit the function.
●
Send [BYE ]
When the transmission is successful, [goodbye] is
returned and the connection is disconnected.
Note
●
The TV automatically will disconnect one minute after
receiving the last data without [BYE] command.
●
Repeating the procedure in 1 to 3 every time you
send / receive a command or a group of commands
is recommended for shortening the time for which the
port is open .
