Panasonic TH-50PF9EK, Operating Instructions Manual

Page: 8 / 48

8
Connections
1
2
1
2
1
2
SERIAL PC IN
AUDIO
SLOT1 SLOT3
P
R
/C
R
/R P
B
/C
B
/B Y/G
AUDIO R L
COMPONENT/RGB IN
SLOT2
AUDIO
DVI-D IN
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suf fi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
Note:
At factory shipment, Terminal board is installed in SLOT 2 and SLOT 3.
Optional Terminal
Board Insert Slot
(covered)
COMPONENT/RGB IN
and Audio IN Terminals
(see page 11)
From EXTERNAL
monitor terminal on
Computer (see page 9)
From SERIAL Terminal
on Computer
(see page 10)
DVI-D IN
Terminals
(see page 11)
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
Speakers (Optional accessories)
AC cord connection (see page 12)
– AC cord fi xing
3. Slide up the clamper and fi x
the AC cord plug securely.
2. Insert the AC cord
and close the clamper
securely.
1. Open the clamper.
Clamper
AC cord
Note: The power plug in the illustration may not be the type fi tted to your set.
When loosen
the clamper:
4. Insert the point of the
fi xed clamper into the
small hole on the lower
r i g h t o f
the back
cover as
necessary.