Panasonic TH-42PF11EK, Operating Instructions Manual, Page: 8 / 56

SERIAL PC IN
AUDIO
SLOT1 SLOT3
P
R
/C
R
/R P
B
/C
B
/B Y/G
AUDIO R L
COMPONENT/RGB IN
SLOT2
AUDIO
DVI-D IN
1 2
1
2
1
2
1
2
8
From SERIAL
Terminal on
Computer
(see page 10) From EXTERNAL
monitor terminal
on Computer
(see page 9) DVI-D IN Terminals
(equivalent of DVI-D
Terminal Board
(TY-FB11DD))
(see page 11) Optional Terminal
Board Insert Slot
(covered) COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of BNC Component Video
Terminal Board (TY-42TM6A))
(see page 11)
Note:
Make sure that the AC
cord is locked on both the
left and right sides.
Push
until
the hook
clicks.
2. Pull
off.
Close
Open
1
Plug the AC cord into the display
unit.
Plug the AC cord until it clicks.
2 Fix the AC cord with the clamper
which is attached to the unit.
For the TH-42PF11EK, TH-58PF11EK:
Clampers are not installed to this
unit. Ensure there is suffi cient slack
in the AC cord and fi rmly bind with
the supplied cable fi xing band, etc.
1. Keep the
knob
pressed.
Connections
Speaker terminal (R)
Speaker
terminal (L)
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
AC cord connection (see page 12)
Speakers (Optional accessories)
Pass the attached cable
fi xing band through the clip
as shown in the fi gure. To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
– AC cord fi xing
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
Unplug the AC cord
Unplug the AC
cord pressing
the two knobs.
Note:
When disconnecting the AC cord,
be absolutely sure to disconnect
the AC cord plug at the socket
outlet fi rst.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.