Panasonic TC-14B3R, Operating Instructions Manual

Page: 12 / 17

11
VCR AND SATELLITE RECEIVER INSTALLATION
Your new TV is supplied with programme position ‘0’set to receive an RF signal from a VCR.
However, if for some reason the VCR is tuned to a different RF channel then you will not receive any picture or sound from the VCR on
programme position ‘0’of the TV. It will be necessary to either adjust the RF channel of the VCR or to adjust the tuning of the TV’s
programme position ‘0’or both until the RF output channel of the VCR is received.
It is intended that this advice is used in conjunction with the instruction books for your ancillary equipment.
rear of
VCR
- + To start search for VCR playback
To return to
viewing screen
To store position
? ?
To select programme position ‘0’(VCR)
Programme position is displayed top left
of screen
Access the Manual tuning menu as
detailed on page 9.
TO TUNE YOUR TV TO THE VCR
Insert
recorded tape
and select
playback
Set TV to
programme
position ‘0’
VCR
Adjust
tuning
Operation
completed
See below for
installation of VCR
and
Satellite Receiver
TO TUNE YOUR VCR TO THE TV
RF CHANNEL ADJUST
Note :
Some VCR’s are capable of adjusting their
RF channel via their remote control unit.
TV/AV
Manual Tuning
: Programme Position
- /+ : Start Search
TV/AV : Store .
F : Previous Menu
N : Exit
21
69
N
VCR
TV/AV
N
If you are going to use a Satellite Receiver and a VCR, it is important, to avoid tuning problems, that they are both tuned to output their
signals on different channels. For example, if your VCR is tuned to output channel 32, your Satellite Receiver could be set to output
channel 34. Refer to your Satellite Receiver and VCR instruction books for precise tuning information.