8.13. SERVICE 11: Voice Recording
Check
Repeats the "SD-card formatting, full recording (recording until
card´s capacity is completely used), and playbacks" procedure,
and checks for voice recording errors.
1. Execute the "8.3 SERVICE 1: EL Display Mode Switching"
procedure so that EL is always ON.
2. Execute menus up to 6 as described in section 8.2
(Entering The Service Mode).
3. Remove the service mode SD-card from the audio player.
Note: The SD-card will be formatted at the SERVICE 11
menu. Therefore, be sure to remove the service mode
SD-card from the audio player.
4. Insert the recording check SD-card into the audio player.
5. Execute the SERVICE 11 menu as described in section 8.2
(Entering The Service Mode).
·
The voice recording error check screen (recording time:
Fig.S12, playback time: Fig.S13) display, then the
"repeated SD-card formatting, full recording (recording
until card´s capacity is completely used), and playback"
procedure begins.
·
The repeat count displays onscreen.
6. The above procedure is repeated until a recording error
occurs. Therefore, if no recording error has occurred after
approximately 2 repeats, open the battery cover to end the
procedure.
* If a recording error occurs, recording is stopped, and an error
code (recording time: Fig.S14, playback time: Fig.S15) displays
onscreen.
For error code details, refer to section 8.16 (Error Code Table).
Fig.S12
Fig.S13
Fig.S14
Fig.S15
15
SV-SD100VEB / SV-SD100VEG / SV-SD100VGC / SV-SD100VGK / SV-SD100VGN / SV-SD100VPP
