Panasonic SJ-MR230DGH, Service Manual

Page: 22 / 65

4. When it ends normally, “0FOK” is displayed on LCD of remote
control and a main part.
It is set to “0FNG” at the time of abnormalities.
5. Press the PLAY key of the remote controller (change the display
of the LCD to “T1E** ” , off-set automatic adjustment will be
finished.).
Note)
When “0FNG” is displayed, check “7. Troubleshooting Guide” in order.
6.2.4. Magneto-optical disc automatically adjustment
1. After “Off-set automatic adjustment” is finished, press the
key of the remote control and make “T2E**” display on LCD.And
move the optical pickup to around the center.
2. Set the full-recorded magneto-optical disc with the prevention
erase situation.
3. Press the PLAY key of the remote controller (“T2E** ” changes to
“0AADJ ” on the LCD, adjustment is started.).
4. If it has been finished normally, “0ADDJ ” changes to “0AOK ” on
LCD. If it is abnormally, it changes to “0ANG ”.
5. Press the PLAY key (“0AOK ” or ”0ANG ” changes to “T2E** ”,
magneto-optical disc adjusment is finished.).
Note:
When “0ANG” is displayed, check “7. Troubleshooting Guide” in order.
6.2.5. Playback-only disc automatically adjustment
1. After “Magneto-optical disc automatically adjustment” is finished,
press the key of the remote control and make “T3J**”
displayedon LCD. And move the optical pickup to around center.
2. Set the playback-only disc.
3. Press the PLAY key of the remote controller (“T3E** ” changes to
“00ADJ ” on the LCD, adjusment is started.).
4. If it has been finished normally, “00ADJ ” changes to “00OK ” on