28
9.12. Disassembly of Tweeter
Speaker (SP1) & (SP2)
Picture shows the location of the Tweeter Speaker (SP1) &
(SP2).
Note :
The disassembling procedure for Tweeter Speaker
(SP1) will be described only.
For Tweeter Speaker (SP2) please refer to the same procedure
described here.
• Refer to “Disassembly of Rear Cabinet Block”
• Refer to “Disassembly of Battery Pack”
• Refer to “Disassembly of Main P.C.B.”
Step 1 :
Remove 4 screws.
Step 2 :
Remove the Tweeter Speaker (SP1).
Caution : During assembling, ensure that the Tweeter
Speaker Terminal are fixed as shown below.
Summary of Contents for SC-NA30GN
