RQTX0151
37
Problem
Possible solution
Pages
HDMI
When VIERA Link “HDAVI
Control” does not function
properly
Con
fi
rm “Setting VIERA Link “HDAVI Control” to “
OFF
”” is set to “
ON
” (in
simultaneous operation).
When it is “
OFF
”, change to “
ON
”.
VIERA Link “HDAVI Control” does not function in power saving standby mode
when this system is turned off. See “Reducing standby power consumption
(Standby mode)” and set to “
ON
” (normal power consumption).
Check VIERA Link “HDAVI Control” settings of the connected equipment.
VIERA Link “HDAVI Control” may not function when you change the connections
for HDMI equipment, insert and remove the outlet, or during blackout. Do the
following operations in this case.
– Turn on the TV (VIERA) on again while all the equipment connected with
HDMI cables are on.
– Set “VIERA Link (HDMI) Control (HDMI equipment control)” of TV (VIERA) to
“OFF” and then set to “ON” again. (For details, refer to the operating
instructions for TV (VIERA).)
– Connect this system to TV (VIERA) using the HDMI cable, switch the TV
(VIERA) on, unplug this system’s AC mains lead, and insert it into a household
mains socket again.
•
•
•
•
31
31
—
—
Reference
Troubleshooting guide/Digital signals that can be played on this system
Note
Playback of the following signals is also available when you make HDMI connections. (
®
pages 17 and 28)
– PCM signals with sampling frequencies of over 96 kHz
– Multi-channel signals with sampling frequencies of over 48 kHz
Ú
Depending on the connected equipment, the playback condition differs. (Playback may be impossible if not supported.)
See operating instructions of playback equipment for more information.
See “Glossary” (
®
page 38) for more detailed information on each signal.
•
•
Dolby Digital
DTS
PCM (2-channel)
Multi-channel LPCM
(Linear PCM)
DVD etc.
DVD etc.
CD, DVD audio etc.
(Signals with sampling
frequencies of up to 96 kHz)
Blu-ray disc, DVD audio etc.
(Signals with sampling
frequencies of up to 48 kHz)
Digital signals that can be played on this system
