22
SQT0858
≥
If the main unit is connected to a Panasonic
TV and turned on using the remote control or
the touch key on the main unit, sound might
not be output from this system. In this case,
turn the main unit on using the TV’s remote
control. (
>
19)
≥
If the connections are correct, there might be
a problem with the cables. Redo the
connections with different cables.
≥
Check the audio output settings on the
connected device.
The dual audio cannot be changed from
main to secondary.
If the audio received from the connected device is not
“Dolby Dual Mono” or the output setting is not
“Bitstream”, the setting cannot be changed from this
system. Change the setting on the connected device.
The volume is lowered when the main unit is
turned on.
“VOL LIMITATION” is on.
If the main unit is turned off with the volume setting
in the greater half (above 50), the main unit will
automatically lower the volume to the middle (50)
when the main unit is turned on. (
>
18)
The dialog is too persistent or the dialog
does not sound natural.
This system has a function to make the dialog
stand out when the volume is low. (
>
17)
The sound lags behind the image.
Depending on the TV, when this unit is
connected to it via Bluetooth
®
, the sound output
from this unit may lag behind the TV image.
Connect this unit and the TV with an HDMI
cable/optical digital audio cable. (
>
8, 9)
Sound stops.
The power of the main unit turns off
automatically.
(When the main unit detects a problem, a safety
measure is activated and the main unit
automatically switches to standby mode.)
≥
There is a problem with the amplifier.
≥
Is the volume extremely high?
If so, lower the volume.
≥
Is this system placed in an extremely hot
place?
If so, move this system to a cooler place and
wait a few moments and then try to turn it on
again.
If the problem persists, confirm the display, turn
this system off, remove the AC mains lead cord
and consult your dealer. Please be sure to
remember the display that was indicated and
inform the dealer.
“F61”
≥
There is a problem with the amplifier of the
system.
≥
Disconnect the AC mains lead and consult the
dealer.
“F70 HDMI”/ “U701”/ “U703”
≥
Check HDMI connection.
≥
Turn off the main unit and then switch it on
again.
≥
Disconnect the HDMI cable.
“F76”
≥
There is a problem with the power supply.
≥
Disconnect the AC mains lead and consult the
dealer.
“U704”
≥
This system is receiving unsupported video
format signal from the input source.
j
Change the video resolution setting on the
connected device. (Refer to the operating
instructions for the device.)
j
If there is no image, connect the device
directly to the TV to change the settings.
“U705”
≥
The TV’s HDMI terminal connected to the
main unit or the TV’s setting is not compatible
with the HDCP 2.2 playback source.
j
Ensure to connect to the TV’s HDCP 2.2
compatible terminal.
j
Ensure the TV’s HDMI HDCP setting
corresponds to HDCP 2.2.
(Refer to the operating instructions for the TV.)
“REMOTE
” (“
” stands for a number.)
The remote control and this unit are using
different codes. Change the code on the remote
control. (
>
14)
Main unit displays
SC-HTE200-SQTxxxx.book 22 ページ ２０１５年４月２７日 月曜日 午前１０時２分
