15
T
Q
BJ
207
4
█
Main unit displays
“--:--”
•
You connected the AC mains lead for the first time or there
was a power failure recently. Set the clock.
“ADJUST CLOCK”
•
The clock is not set. Adjust the clock.
“ADJUST TIMER”
•
The play timer is not set. Adjust the play timer.
“AUTO OFF”
•
The system has not been used for 20 minutes and will
switch off within a minute. To cancel, press any button.
“ERROR”
•
An incorrect operation was done. Read the instructions and
try again.
“F61”
“F77”
•
Disconnect the AC mains lead and consult your dealer.
“F703”
•
Examine the Bluetooth
®
connection.
•
Disconnect the Bluetooth
®
device. Switch off the system
and then switch on again.
“F76”
•
There is a problem with the power supply.
•
Disconnect the AC mains lead and consult your dealer.
“ILLEGAL OPEN”
•
The sliding door is not in a correct position. Switch off the
system and then switch on again.
“NO DEVICE”
•
The USB device is not connected. Examine the connection.
“NO DISC”
•
You have not put in a disc.
“NO PRESET”
•
DAB memory presetting has not been done.
“NO PLAY”
•
Examine the content. You can only play supported format.
•
The files in the USB device may be corrupted. Format the
USB device and try again.
•
The system may have a problem. Switch off the system and
then switch on again.
“NO SIGNAL”
•
The station cannot be received. Adjust the antenna.
“PLAYERROR”
•
You played an unsupported MP3 file. The system will skip
that track and play the next one.
“LINKING”
•
This system is trying to connect to the last connected
Bluetooth
®
device when “BLUETOOTH” is selected.
“READING”
•
The unit is checking the “CD/USB” information. After this
display has disappeared, start operating.
“REMOTE 1”
“REMOTE 2”
•
The remote control and the main unit are using different
codes. Change the code of the remote control.
–
When “REMOTE 1” is shown, press and hold [OK] and
[ ] for a minimum of 4 seconds.
–
When “REMOTE 2” is shown, press and hold [OK] and
[USB/CD] for a minimum of 4 seconds.
“SCAN FAILED”
•
Stations cannot be received. Adjust the antenna or perform
the “AUTO SCAN” tuning function. (
~
10)
If “SCAN FAILED” is still shown, find the best signal
reception with the “MANUAL SCAN” tuning function.
(
~
10)
“SOUND 1 NOT SET”
“SOUND 2 NOT SET”
“SOUND 3 NOT SET”
•
You have not saved the sound effects into the sound setting
number.
“USB OVER CURRENT ERROR”
•
The USB device is using too much power. Disconnect the
USB device, switch off the system and then switch on again.
•
Check the connection, it may be caused by a faulty USB
cable.
“VBR”
•
The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
“NOT SUPPORTED”
•
You have connected an unsupported USB device.
SC-HC302.300.GN.GS TQBJ2074 En_rev1.fm Page 15 Friday, March 23, 2018 9:59 AM