Panasonic SC-BTT430, Operating Instructions Manual

Page: 44 / 112

44
VQT4Z41
Changing the sound
settings
For more details on each setting, refer to “Sound
Settings” on the Option menu. (
> 36)
1
Press [SURROUND].
2
Press [
3
,
4
] to select “MULTI CH SOURCE”
or “2CH SOURCE”, and then press [OK].
e.g.,
3
While the mode is displayed
Press [
3 , 4 ] to select the desired setting.
( > 36)
∫ Adjusting speaker level during play
1
Press [CH SELECT] to activate the speaker
setting mode.
2
Press [CH SELECT] several times to select
the speaker.
≥
Press [
2
,
1
] to adjust the balance of the
front speakers.
3
Press [
3
] (increase) or [
4
] (decrease) to
adjust the speaker level for each speaker.
s
6 dB to
r
6 dB
1
Press [SOUND].
2
Press [
3
,
4
] to select “2CH SOURCE” or
“ALL SOURCE”, and then press [OK].
e.g.,
3
While the mode is displayed
Press [
3
,
4
] to select the desired setting and
press [OK].
Repeat this procedure if necessary. (
> 36)
≥ The sound effects/modes may not be available or have no
effect with some sources.
≥ You may experience a reduction in sound quality when
these sound effects/modes are used with some sources. If
this occurs, turn the sound effects/modes off.
Speaker installation
option
Consult a qualified building contractor when
attaching the speakers to a wall. Improper
attachment may result in damage to the wall and
speakers and personal injury.
You can attach all of the speakers (except
subwoofer) to a wall.
≥
The wall or pillar on which the speakers are to
be attached should be capable of supporting
10 k
g
per screw.
1
Drive a screw (not supplied) into the wall.
A
At least 30 mm
B
‰
4.0 mm
C
‰
7.0 mm to
‰
9.4 mm
D
Wall or pillar
E
5.5 mm to 7.5 mm
2
Fit the speaker securely onto the screw(s)
with the hole(s).
Use the measurements indicated below to identify
the screwing positions on the wall.
≥
Leave at least 20 mm of space above the
speaker and 10 mm on each side to allow
enough space for fitting the speaker.
Surround Effects
Sound Effects
Attaching to a wall
e.g., Front speaker
DO NOT DO
≥ In this position, the
speaker will likely fall if
moved to the left or right.
≥ Move the speaker so
that the screw is in this
position.





SC-BTT430GA-VQT4Z41_mst.book 44 ページ ２０１３年３月１８日 月曜日 午後１２時３分