Panasonic SAXR25 - DIGITAL A/V RECEIVER, Operating Instructions Manual

Page: 11 / 24

11
RQT6840
COMPLETE
Adjusting speaker output
level 3 5
S E T U P
Change the setting.
Select “FILTER”.
F I LT E R
1 0 0
100, 150, 200
Output the signal.
TEST
SA-XR25
SA-XR45
-TEST/–SETUP
T E S T
L
L C R RS SB LS SW
VOLUME
Adjust the main
volume.
–/L +/R
LEVEL
Adjust the level.
C 0 d B
C, RS, SB, LS, SW
C 4 d B
-10 dB +10 dB
---, MIN, 1 19, MAX
TEST
SA-XR25
SA-XR45
-TEST/–SETUP
Stop the test signal.
Repeat.
FILTER
Step 3
Two seconds each.
Select the speaker
channel.
Change these settings to suit the
connections you have made to the optical
(OPT) and coaxial (COAX) digital input
terminals, so that the correct source is
selected when you press [INPUT
SELECTOR].
The factory settings are:
4 D-INPUT
Digital input
Select “D-INPUT”.
Select the input position.
Change the setting.
D - I N P U T
O P T 1
TV, DVD, DVR, CD
T V
SA-XR25
SA-XR45
TV, DVD, CD
O P T 1
OPT 1, OPT 2, OPT 3, COAX
SA-XR25
SA-XR45
OPT 1, OPT 2, COAX
Repeat.
TV: OPT 1
DVD: OPT 2
CD: COAX
TV: OPT 1
DVD: OPT 2
DVR: OPT 3
CD: COAX
Change the settings to suit your equipment to the environment in which you are using it. Before making any changes, read the descriptions of the
settings, note the factory settings and ranges, and refer to the equipment’s instructions.
SA-XR25 SA-XR45
Change the cut-off for bass
output from the front speakers
If you set the front speakers to “SMALL”,
the filter is set to 100 Hz. Raise the cut-off
if the bass from the front speakers is
unsatisfactory so that this bass is output
through the subwoofer.
You can raise the cut-off from 100 Hz to
either 150 Hz or 200 Hz.
Adjust the level of the other speakers based on the
output of the front speakers. (Speakers set as “NONE” or
“NO” are skipped. Adjust the volume of the front speakers
with [VOLUME].)
C (center), RS (right surround), SB (surround back) and
LS (left surround) can be adjusted between –10 dB and
+10 dB, with 0 being the level of the front speakers.
Adjust center, surround and surround back output to the
same apparent level of the front speakers.
For SW (subwoofer), you can select “– – –” so there is no
output, “MIN” for minimum output, a level between 1 and
19, or “MAX” for maximum output.
Adjust subwoofer output so it is balanced with the front
speakers. Subwoofer output is easily influenced by the
source. You can also change its level while playing
something for better effect (
\
page 18).