14
1
Attach a cord (not supplied) to 2 safety holders.
≥
Keep the safety holders out of reach of children to prevent swallowing.
≥
Keep the remaining 2 safety holders for later use.
2
Adjust the safety holder with the cord attached (
>
above), to fit the
projecting parts and screw the safety holder firmly into place.
≥
Screw tightening torque: 80 N
0
cm (17.98 lbf-ft) to 120 N
0
cm (26.98 lbf-ft).
≥
The safety holder is to minimize the possibility of damage and harm, but it does not guarantee this effect.
≥
Keep the safety holders out of reach of children to prevent swallowing.
≥
Keep the screws out of reach of children to prevent swallowing.
3
Place the unit in the desired position and attach each cord onto the rack or
table.
≥
Make sure that the slack is minimal.
≥
Keep the screws out of reach of children to prevent swallowing.
When the supplied leg stands are not used
A
Safety holder (supplied)
B
Cord (not supplied)
C
Thread a cord through the holes.
Refer to the Owner’s Manual of the
cord for details.
D
Screw with washer (supplied)
E
Safety holder (supplied)
F
Projecting part
G
Screw eye (not supplied)
≥
Attach at a position capable of
supporting over 33 k
g
(72.8 lbs).
≥
Depending on the placement of
the unit, the screwing position of
the screw eye may differ.
突起部
≥
The safety holder is placed diagonally.
SC-HTB520PP_RQTX1278-Y.book Page 14 Friday, February 18, 2011 8:48 AM
