Panasonic SA-AK600GC, Service Manual, Page: 4 / 134

Note that this unit will be seriously damaged if this setting is not made correctly. (There is no
voltage selector for some countries, the correct voltage is already set.)
2. Before Repair and Adjustment
Disconnect AC power, discharge Power Supply Capacitors C571-C574 and C581 through a 10 ,
5W resistor to ground.
DO NOT SHORT-CIRCUIT DIRECTLY (with a screwdriver blade, for instance), as this may destroy
solid state devices.
After repairs are completed, restore power gradually using a variac, to avoid overcurrent.
Current consumption at AC 240 V, 50 Hz in NO SIGNAL mode should be ~800mA.
3. Protection Circuitry
The protection circuitry may have operated if either of the following conditions are noticed:
- No sound is heard when the power is turned on.
- Sound stops during a performance.
The function of this circuitry is to prevent circuitry damage if, for example, the positive and
negative speaker connection wires are
“shorted”, or if speaker systems with an impedance less than the indicated rated impedance of
the amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first turned
off and then on again.
4. Accessories
Remote Control Transmitter
FM indoor antenna
AC mains lead (for GC only)
4