Panasonic SA-AK500P, Service Manual

Page: 132 / 229

file:///D|/Documentos/Manolo/Service/Panasonic/Manuales/Audio/SA-AK500P_SA-AK500PC/SVC/s1402000000.html[17/03/2009 01:02:23 p.m.]
42 DSLF2 O Tracking Offset alignment output/DSL Balance Output (DA Output)
43 WVEL O N.C.
44 ARF I RF signal input
45 IREF I Reference current input
46 DRF I DSL bias terminal (Not used, open)
47 DSLF I/O DSL loop filter terminal
48 PLLF I/O PLL loop filter terminal
49 VCOF I/O VCO loop filter terminal
50 AVDD2 I Power supply input (for analog circuit)
51 AVSS2 I GND (for analog circuit)
52 EFM - EFM signal output
53 PCK - PLL extraction clock output (fPCK = 4.321 MHz during normal playback)
54 VCOF2 I/O VCO Loop filter for 33.8688 MHz conversation terminal for 16.9344 MHz crystal mode, must use other circuit
55 SUBC O Sub-code serial data output
56 SBCK I Clock input for sub-code serial data
57 VSS I GND
58 X1 IN I Crystal oscillating circuit input (f = 16.9344MHz)
59 X2 OUT O Crystal oscillating circuit input (f = 16.9344 MHz)
60 VDD I Power supply input (for oscillating circuit)
61 BYTCK - Byte clock output
62 /CLDCK - Sub-code frame clock signal output (fCLDCK = 7.35 kHz during normal playback)
63 FCLK - Crystal frame clock signal output (fCLK = 7.35 kHz, double = 14.7 kHz)
64 IPFLAG - Interpolation flag output (“H” : Interpolation)
65 FLAG - Flag output
66 CLVS - Spindle servo phase synchronizing signal output ("H" : CLV, "L" : rough servo)
67 CRC - Sub-code CRC checked output (“H’ :OK, “L” :NG)
68 DEMPH - De-emphassis ON signal output (“H” :ON)
69 RESY - Frame re-synchronizing signal output
70 IOSEL I Mode Switching Terminal
71 /TEST I Test input
72 AVDD1 I Power supply input (for analog circuit)
73 OUTL O Left channel audio signal output
74 AVSS1 I GND
75 OUTR O Right channel audio signal output
76 RSEL I RF signal polarity assignment input (at "H" level, RSEL="H", at "L" level, RESL="L")
77 IOVOD I 5V supply input
78 PSEL I Test terminal (connected to Gnd)
79 MSEL I SMCK oscillating frequency designation input (“L”:4.2336 MHz, “H”:8.4672 MHz)
80 SSEL I SUBQ output mode select (“H”:Q-code buffer mode)
TOP PREVIOUS NEXT