background image

Take note of the following points to extend the life of your equipment.
Always read the instructions provided with the software.

Discs

Choose discs with this mark:

This unit may not be able to play some CD-R due to the condition of the
recording. It cannot play CD-RW.

Continued use of irregular shaped CDs
can damage the unit.

Do not;

• use discs that have extra labels or stickers attached.

Carefully remove leftover adhesive before use.

• attach scratch-proof covers or any other kind of accessory.
• write anything on the CD.
• clean CDs with liquids.

Wipe with a soft, dry cloth.

• use CDs printed with label printers available on the market.

Tapes

• Tapes exceeding 100 minutes are thin and can break or get caught in

the mechanism.

• Tape slack can get caught up in the mechanism and should be taken

up before the tape is played.

• Endless tapes can get caught up in the deck’s moving parts if used

incorrectly.

Frequency range

FM

87.9–107.9 MHz (200 kHz steps)

87.5–108.0 MHz (100 kHz steps)

AM

520–1710 kHz (10 kHz steps)

Sampling frequency

44.1 kHz

Decoding

16 bit linear

Beam source

Semiconductor laser (wavelength 780 nm)

No. of channels

2 channel, stereo

Wow and flutter

Less than possible measurement data

D/A converter

1 bit DAC

Track system

4 track, 2 channel, stereo

Monitor system

Variable sound monitor

Recording system

AC bias

Erasing system

Multi Pole magnet

Frequency range

Normal position

50–12000 Hz

Speakers

Full range

10 cm (3

15

/

16

˝) 4

  x 2

Center speaker (For RX-D15 only)

1.5 cm (

19

/

32

˝)

Jacks

Output

PHONES: 3.5 mm stereo (32

)

Power requirement

AC

120 V, 60 Hz

Power consumption: 14 W

Battery

9 V (Six R20/LR20, D, UM-1 batteries)

• Do not use rechargeable type batteries.

Memory back-up

6 V (Four R6/LR6, AA, UM-3 batteries)

• Do not use rechargeable type batteries.

Dimensions (WxHxD)

420 x 167 x 275 mm ( 16

17

/

32

˝ x 6

31

/

32

˝ x 10

13

/

16

˝ )

Mass

(RX-D15) 3.6 kg (7 lb. 15 oz.) without batteries

(RX-D13/RX-D12) 3.4 kg (7 lb. 8 oz.) without batteries

Power consumption in standby mode: 1 W

 Note

Specifications are subject to change without notice.
Mass and dimensions are approximate.

If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of Authorized
Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
For detailed instructions, contact an authorized servicenter in the U.S.A. and Panasonic Canada Inc. Customer Care Centre in Canada.
In the U.S.A., call 1-800-211-7262, e-mail [email protected], or visit www.panasonic.com
In Canada, call 905-624-5505 or visit www.panasonic.ca

Panasonic Consumer Electronics
Company, Division of Matsushita
Electric Corporation of America

One Panasonic Way Secaucus,
New Jersey 07094
http://www.panasonic.com

Panasonic Sales Company,
Division of Matsushita Electric of
Puerto Rico, Inc. (“PSC”)

Ave. 65 de Infantería, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985

Panasonic Canada Inc.

5770 Ambler Drive
Mississauga, Ontario
L4W 2T3
www.panasonic.ca

RQT5685-2P

L1100TL2071

© 2000 Matsushita Electric Industrial Co., Ltd.
Printed in China

xx

xx

xx

xxx

xx

xx

xx

xx

xx

x

xx

xx

xx

xxx

xx

xx

xx

xx

xx

xx

xx

xxx

xx

xxx

xx

x

XXXX XXXX XXXXX

XXXX XX

XXXX XXXX XXXXX

XXXX XXXX XXXXX

XXXX XXXX 

Troubleshooting guide

En

Specifications

Audio software

Common Problem

The unit doesn’t work on batteries.

“UO1” is displayed.

Is the AC power cord connected to the unit? Disconnect when using batteries.
Have the batteries been inserted correctly? Check that the poles (+ and –) are correctly aligned.
Replace the batteries or use household AC power.

CD

“E” is displayed.
Play doesn’t start or display is incorrect.

Indicates an incorrect operation. Read the instructions.
Clean the CD.
Wait for an hour for condensation to dry, then try again.
Make sure the label is facing up.
Replace the CD if it is scratched, warped, or irregularly shaped.

Cassette

Recording not possible.
Poor sound quality.
The cassette cannot be ejected or the lid can’t be
closed when loading a cassette.

Has the cassette’s tab been removed? Cover the hole with adhesive tape.
Clean the heads.
The batteries are flat. Replace the batteries or connect to household AC power.
Press [

-

 PLAY] then [

L

/

c

 STOP/EJECT].

Radio

A lot of noise.

Is another remote control being used? Use it further away from this unit.
Is a TV on? Move the unit away from the TV or turn it off.

Remote control (available only for RX-D15 and RX-D13)

The remote control doesn’t work.

Check the batteries are inserted correctly.
Replace the batteries if they are worn.

P8  latest

3/25/05, 12:05 AM

8

Summary of Contents for RXD12 - RADIO CASS. W/CD-LOW









Reviews: