Panasonic RX-D27E, Manuals

Page: 75 / 84

Pin
No.
Mark I/O Function
1 VLC1 - LCD bias
2 VLC2 - LCD bias
3 VLC3 - LCD bias
4 NC - NO Connection
5 NC - NO Connection
6 MUTE_A O Muting signal A
7 PCONT O Power control output
8 MBP1 O Beat proof control 1
9 MBP2 O Beat proof control 2
10 NATRST I Connect to GND
11 VSS - GND
12 OSC OUT O 8MHz OSC output
13 OSC IN I 8MHz OSC input
14 MMOD I Connect to GND
15 XIN I 32 kHz OSC input
16 XOUT O 32 kHz OSC output
17 VDD - VDD +3.3V
18 RESET I Reset input
19 VREF+ - +3.3V Reference for A/D
20 KEY A-
D
Key input
21 REG_1 A-
D
Region setting
22 REG_2 I Unused (connect to GND)
23 YOB1 A-
D
Unused (connect to GND)
24 PDET A-
D
Power supply voltage detect
25 YOB2 I Unused (pull up)
26 AGCLK O ASP IC clock
27 AGDATA O ASP IC data
28 VREF- - Analog reference GND
29 VDD - VDD +3.3V
30 MDATA O CD signal processor control
data out
31 STAT I/O CD status input
32 MCLK O CD signal processor control
clock out
33 MLD O CD signal processor control
load out
34 NOT USE O Unused (connect to GND)
Pin
No.
Mark I/O Function
35 NOT USE O Unused (connect to GND)
36 REST-SW I CD reset switch input
37 CD-REST I/O CD rest control
38 CLOSE SW I CD close/open detect
39
REM_CONT I/O Remote control output L
40 REC-H I Tape REC H
41 TAPE-L I Tape play L
42 STBY-LED
1
O Stby-led control output
43 BLKCK I/O CD subcode block clock
44 RMIN I Remote control input
45 VCCDET I Remote control input
46 ACDET I AC power supply detect
47 VDD - VDD +3.3
48 E-DATA O Eeprom data
49 E-CLK O Eeprom clock
50 E-CS O Eeprom chip select
51 PLL-DO I/O PLL count data input
52 PLL-DI O TU PLL-data output
53 PLL-CK O TU PLL-clock output
54 PLL-CE O TU PLL-CE output
55 STBY-
LED2
O Stby-LED active H
56~59 NOT USE I Unused (connect to GND)
60~79 SEG 19~0 O LCD segment drive output
80 NC - NO Connection
81~84 COM 0~3 O LCD common output
75