Frequency range
FM
87.50–108.00 MHz (50 kHz steps)
AM
522–1629 kHz (9 kHz steps)
Sampling frequency
44.1 kHz
Decoding
16 bit linear
Beam source
Semiconductor laser (wavelength 780 nm)
Bølgelengde
780 nm
Laser-styrke
Ingen farlig strålning sendes ut
(med sikkerhets-beskyttelse)
No. of channels
2 channel, stereo
Wow and flutter
Less than possible measurement data
D/A converter
1 bit DAC
Track system
4 track, 2 channel, stereo
Monitor system
Variable sound monitor
Recording system
AC bias
Erasing system
Multi Pole magnet
Frequency range
Normal position
50–12000 Hz
Speakers
Full range
10 cm 4
Ω
x 2
Center speaker (RX-D19 only)
1.5 cm
Jacks
Output
PHONES: 3.5 mm stereo (32
Ω
)
Power requirement
AC
230-240 V, 50 Hz
Power consumption: 11 W
Battery
9 V (Six R20/LR20, D, UM-1 batteries)
• Do not use rechargeable type batteries.
Memory back-up
6 V (Four R6/LR6, AA, UM-3 batteries)
• Do not use rechargeable type batteries.
Dimensions (WxHxD)
420 x 167 x 275 mm
Mass
(RX-D19) 3.6 kg without batteries
(RX-D17) 3.4 kg without batteries
Note
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Matsushita Electric Industrial Co., Ltd.
Web Site: http://www.panasonic.co.jp/global/
RQT6341-B
L1101TC0
En
Specifications
Take note of the following points to extend the life of your equipment.
Always read the instructions provided with the software.
Discs
Choose discs with this mark:
Continued use of irregular shaped CDs
can damage the unit.
Do not
• use CDs with labels and stickers that are
coming off or with adhesive exuding from
under labels and stickers.
• attach scratch-proof covers or any other
kind of accessory.
• write anything on the CD.
• clean CDs with liquids.(Wipe with a soft, dry cloth.)
• use CDs printed with label printers available on the market.
• load a blank CD-R as it will cause abnormal malfunction and may
damage the CD-R.
Cassette tapes
• Tapes exceeding 100 minutes are thin and can break or get caught in
the mechanism.
• Tape slack can get caught up in the mechanism and should be taken
up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts if used
incorrectly.
Audio software
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of Authorized
Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
Troubleshooting guide
Common Problem
The unit doesn’t work on batteries.
“UO1” is displayed.
Is the AC mains lead connected to the unit? Disconnect when using batteries.
Have the batteries been inserted correctly? Check that the poles (+ and –) are correctly aligned.
Replace the batteries or use household AC power.
CD
“E” is displayed.
Play doesn’t start or display is incorrect.
Indicates an incorrect operation. Read the instructions.
Clean the CD.
Wait for an hour for condensation to dry, then try again.
Make sure the label is facing up.
Replace the CD if it is scratched, warped, or irregularly shaped.
Cassette
Recording not possible.
Poor sound quality.
The cassette cannot be ejected or the lid can’t be
closed when loading a cassette.
Has the cassette’s tab been removed? Cover the hole with adhesive tape.
Clean the heads.
The batteries are flat. Replace the batteries or connect to household AC power.
Press [
/
PLAY] then [
L
/
c
STOP/EJECT].
Radio
A lot of noise.
Is another remote control being used? Use it further away from this unit.
Is a TV on? Move the unit away from the TV or turn it off.
Remote control
RX-D19 only
The remote control doesn’t work.
Check the batteries are inserted correctly.
Replace the batteries if they are worn.
P8
11/21/01, 7:04 PM
8
