Panasonic Quasar PV-D300, Service Manual

Page: 18 / 199

5.1.7. HOW TO REMOVE A JAMMED
TAPE
CAUTION:
If loading does not start after DC Power Supply is applied,
DO NOT continue applying DC Power Supply.
5.1.7.1. Remove a jammed tape as
follows:
1. Remove a Screw and remove the EVR Cover.
Fig. 4-1
2. Place the unit with the Cassette Cover facing upward.
3. Connect the TP Board Kit through the TP Board slot.
4. Apply +3VDC Power Supply to TP20 (+) and TP21 (-) on
the TP Board to unload the mechanism. It normally takes
approx. 6 seconds to unload the Mechanism to EJECT
position. Then, remove the Power Supply and remove the
TP Board Kit.
Fig. 4-2
5. Open the Cassette Cover fully.
6. Remove the tape slack by rotating the Takeup Reel Gear of
the cassette tape as shown in Fig. 4-3.
Fig. 4-3
7. Take out the cassette tape.
8. Connect the Power or Battery to set the Mechanism to
STOP Position.
20
PV-D300 / VM-D100 / PV-L550 / PV-L600 / PV-L650 / VM-L450