Panasonic PV-GS19PL, Service Manual

Page: 42 / 120

14. Removal of CCD C.B.A., Filter Rubber, Optical Filter,
Filter Holder
CAUTION:
1) When removing the CCD C.B.A., take care that the
Optical Filter does not fall out.
2) Use extreme caution when removing the CCD C.B.A.
as it is easily damaged by static electricity. Use a Wrist
Strap while removing and installing.
3) Do not touch the CCD window surface.
Installation of CCD C.B.A., Filter Rubber, Optical Filter,
Filter Holder
Install in order shown below.
1) Install the Filter Holder (For model with 30X zoom)
correctly.
2) Install the Optical Filter correctly.
Note: Make sure that no dust gets on the Optical Filter
or in the Lens Unit. Clean the Optical Filter with lens
cleaning paper dampened with lens cleaner if
necessary.
3) Install the Filter Rubber on the Optical Filter correctly as
shown below.
Note: Make sure that no dust gets on the Filter
Rubber.
4) Install the CCD C.B.A. into the Lens Unit. Then, tighten
the 2 Screws (536).
Note: Do not touch the Lens Surface. Clean the surface
with lens cleaning paper dampened with lens cleaner
if necessary.
15. Installation of Zoom Motor Unit/Focus Motor Unit
Install the Zoom Motor Unit/Focus Motor Unit so that the
Shaft of the Zoom Motor Unit/Focus Motor Unit is set in the
Holder.
Fig. D15
16. Installation of EVF Slide Piece, EVF Base Frame
1) Pass the EVF F.P.C. through the EVF Base Frame
hole.
2) Install the EVF Slide Pieces into the EVF Base Frame
from both sides.
3) Slide the EVF Case Ass'y to the end so that the ribs are
inserted into the holes of the EVF Slide Pieces.
4) Locate the threaded holes, and tighten the 2 Screws
(450).
5) After installing, confirm the EVF moves correctly.
Fig. D16
Focus
Motor
Unit
Zoom
Motor
Unit
shaft
shaft
holder
holder
Bosses
Bosses
hole of EVF
Slide Piece
hole of EVF
Slide Piece
rib
hole
EVF F.P.C.
EVF Case Ass'y
EVF Base Frame
rib
<Top View>
<Side View>
EVF Slide Piece
EVF Base Frame
(threaded hole)
Slide
450
42
PV-GS19PL / PV-GS31PL / PV-GS35PL