[DC OUT]
This function can be used to supply power by the <DC OUT> terminal.
1) Press
as
to select [DC OUT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Power is supplied to an external device connected to the <DC OUT> terminal.
[OFF]
Power is not supplied to an external device connected to the <DC OUT> terminal.
Note
f
Power supply is ceased in standby mode even when [DC OUT] is set to [ON].
f
If [DC OUT] is set to [ON] and a device which exceeds the rated power (DC 5 V, maximum 2 A) is connected to the projector, the projector
detects an error and ceases the power supply to the device. In such case, [ERROR] is displayed on the [DC OUT] screen. When [ERROR]
appears, remove the device and then switch off and on the power of the projector.
[INITIALIZE ALL]
Return various setting values to their factory default settings.
1) Press
as
to select [INITIALIZE ALL].
2) Press the <ENTER> button.
3) When the [INITIALIZE ALL]
screen is displayed, press
qw
to select [OK] and then press the <ENTER>
button.
4) When the power off confirmation screen is displayed after a while, press the <ENTER> button.
f
The operations except for powering off are disabled.
Note
f
When the [SECURITY] menu → [PASSWORD] is set to [ON], the
[PASSWORD]
screen will be displayed after selecting [INITIALIZE ALL]
and pressing the <ENTER> button. Enter the security password set for the projector and continue your desired operation.
f
The projector will enter the standby status to reflect the setting values when [INITIALIZE ALL] is executed.
f
Even if [INITIALIZE ALL] is performed, the settings of the following items cannot be initialized.
g
[STANDBY MODE]
g
[EMULATE]
g
[FILTER COUNTER]
g
[NETWORK]
f
To initialize the settings of [NETWORK], perform the [NETWORK] menu → [INITIALIZE].
f
When [INITIALIZE ALL] is executed, the
[INITIAL SETTING]
screen is displayed when the projection starts next time.
82 -
ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
