Maintenance
Care and Replacement
E
NGLISH - 42
2. Use a Phillips screwdriver to turn the
lamp unit cover fixing screws
at the bottom of the projector, and then
remove the
Lamp unit cover
.
3. Use a Phillips screwdriver to loosen the two
lamp unit cover fixing screws
until the screws turn freely.
Then hold the handles of the
Lamp unit
and gently pull the
Lamp unit
out from the projector.
4. Insert the new
Lamp unit
while making sure that the direction of insertion is correct, and then use a Phillips
screwdriver to securely tighten the
lamp unit fixing screws
.
When inserting the new
Lamp unit
, be sure to push it in at the point
and
.
5. Install the
Lamp unit cover
, and then use a Phillips screwdriver to securely tighten the
lamp unit cover fixing
screws
.
6. Connect the
Power cord
.
7. Press the
POWER
button so that a picture is projected onto the screen.
8. Press the
MENU
button to display the menu screen, and then press the
F
or
G
button to select the “
OPTION
”
menu.
9. Press the
ENTER
button, and then press the
F
or
G
button to select “
LAMP RUNTIME
”.
10.Press and hold the
ENTER
button for approximately 3 seconds.
The “
LAMP RUNTIME
” screen will be displayed.
11.Press the
POWER
button to turn off the power.
12.Disconnect the
Power cord
after the
POWER
button on the projector illuminates red.
This will reset the cumulative usage time for the lamp unit to “0”.
NOTE:
• Be sure to install the
Lamp unit
and the
Lamp unit cover
securely. If they are not securely installed, it may
cause the protection circuit to operate so that the power cannot be turned on.
NOTE:
• If “
DIRECT POWER ON
” in the “
OPTION
” menu has been set to “
ON
”, projection will start after the
Power
cord
is connected.
See “DIRECT POWER ON” on page 35.
NOTE:
• Press any button other than the
POWER
button to cancel the “
LAMP RUNTIME
” screen.
Lamp unit cover
lamp unit cover fixing screws
Handles
lamp unit fixing screws
A
B
