E
NGLISH
-51
Care
and
m
aintenance
Remedy
Problem
Indicator
display
Flashing (red)
It is nearly time to
replace the lamp
unit.
Illuminated (red)
An abnormality has been detected in the lamp
circuit.
B
Does “REPLACE
LAMP” appear on
the screen after
the projector is
turned on?
B
This occurs when
the operation time
for the lamp unit is
nearing 1 800
hours (when
“LAMP POWER”
has been set to
“HIGH”). Ask your
dealer or an
Authorised
Service Centre to
replace the lamp
unit.
Possible
cause
B
The power may
have been turned
on straight away
after it was turned
off.
B
Wait for a while
until the lamp unit
cools down before
turning the power
back on again.
B
There may be an
abnormality in the
lamp circuit.
B
Disconnect the
mains lead by
following the
procedure on
page 26, and then
contact an
Authorised
Service Centre.
LAMP indicator
NOTE:
B
Be sure to disconnect the mains lead by following the procedure given
in “Turning off the power” on page 26 before carrying out any of the
procedures in the “Remedy” column.
B
If the power turns off after the TEMP indicator has illuminated, it means
an abnormality has occurred. Please contact an Authorised Service
Centre so that the necessary repairs can be made.
