Getting Started
¤
1
–3–
1-C Battery Installation
The unit requires 3 AA (R6, UM-3) size alkaline batteries (not
supplied). The batteries will last about 30 hours with normal use.
1
Remove the cover.
2
Install (or replace) the batteries using the correct polarity
(
r
,
s
) and close the cover.
≥
Make sure that the unit is powered OFF before replacing the
batteries.
≥
When the batteries have been replaced, your channel and group
code settings will be erased. Reprogram if necessary.
Battery precautions:
The batteries should be used correctly, otherwise the unit may be
damaged by battery leakage.
≥
Do not mix different types of batteries.
≥
Do not charge, short-circuit, disassemble or heat batteries, and do
not dispose of batteries in fire.
≥
Remove all the batteries when replacing.
Battery strength:
You can check the battery strength on the display (see below) while
the unit is in use. If the unit
beeps intermittently and “
”
flashes on the display, replace
all the batteries with new ones.
Full
Medium
Low
(flashing)
1-F Turning the Power ON/OFF
1
Press and hold
(POWER)
.
≥
The display will appear.
2
To turn the power off, press and hold
(POWER)
until the display disappears.
1-E Adjusting the Antenna
The antenna rotates 360 degrees. You can adjust the antenna to
three different click positions. For best performance, the antenna
should be used in the vertical position.
You can hang the unit on your belt or pocket using the belt clip.
1-D Belt Clip