Panasonic Omnivision VHS PV-V402, Service Manual

Page: 26 / 105

3. Holes on Main Cam Gear
A. The EJECT mode Hole on Main Cam Gear should be a Through Hole
with Hole A on Support Angle in EJECT mode. The each mode Hole
on Main Cam Gear should be a Through Hole with Hole B on
Support Angle in each mode.
Fig. J3-5
4. Main Cam Gear Kit
A. Main Cam Gear is supplied as a Main Cam Gear Kit only (Kit No.
VVGS0009).
Main Cam Gear Kit consists of a Main Cam Gear and a Main Cam
Push Nut.
However, Main Cam Push Nut is available separately as a
replacement part.
5. Installation of Main Cam Gear and Main Cam Push Nut
A. After installing the Support Angle, install the Main Cam Push Nut
with Needlenose Pliers etc. so that it is flush with the chassis.
There may be some slight scratches on the Shaft of Main Cam Gear,
when removing the Main Cam Gear. In case that the Main Cam Gear
can be installed securely without tottering, it is fine to use the one. If
any tottering, install all new parts.
Fig. J3-6
26