SV121 HV61 HV51 MV21 MV16
SV121 HV61
MV21
HV51
MV16
SV121 HV61
MV21
HV51
MV16
VCR
3
1
2
3
1
2
3
AC IN~
Antenna
RF IN
Antenna input
RF OUT
Antenna output
Antenna input
RF coaxial cable
TV
AC mains lead
AC mains lead
10
Connecting with RF Coaxial cable
Connect antenna to the
RF IN (Antenna input)
connector of the VCR.
Connect the VCR´s RF OUT
(Antenna output) to the
television set’s antenna in
connector.
Connect VCR and television
set to the AC mains supply.
Follow the steps
described below.
Disconnect power to
all devices.
You can connect the VCR to your TV set
by using a RF coaxial cable.
VCR Auto Setup with RF Coaxial cable
D
Mind that a wrong date or time will influence the programmed
recording of TV programmes (don't forget to change summer time
and winter time).
D
If the Country menu does not
appear after turning the device on,
you may reset the device to its
factory defaults (page 17). Upon
doing so the VCR Auto Setup will
start again.
The Country menu appears
.
!
With the arrow buttons
select the according country, and
confirm with
ENTER
.
Automatic tuning for all receivable TV stations begins.
Approximate duration is 5 minutes.
If menu Clock set appears
If time and date are not transmitted by a TV station, they must be set
manually.
!
Enter Time and Date with
or
...
, then
save with
ENTER
.
1
2
3
0
After running the automatic tuning Time and Date must be set
manually.
!
Enter Time and Date with
or
...
, then
save with
ENTER
.
1
2
3
0
(Automatic tuning)
