14
Before Requesting
Service
Before requesting service, check the following
points again.
VCR (Line Recording) will not operate.
[Mains lead not connected.]
• Reconnect mains lead to mains outlet.
[Safety devices operating.]
• Disconnect mains lead and wait for 1 minute.
Reconnect mains supply and check functions.
[An unknown language appears on the screen.]
• Select the desired language. See page 4.
Picture noisy or not in colour.
Horizontal bars or lines run down the screen.
[Video heads clogged or worn.]
• Condensation may have formed, or a faulty
tape has been used. See page 3.
Do not operate VCR (Line Recording) for
1 hour, then insert a new tape (original may be
faulty) and play back for a few minutes. If fault
does not clear, consult your dealer for further
advice.
[Tape defective due to surface damage or wear.]
• Check another tape to see if noise-free and
replace defective tape.
VCR (Line Recording) rewinds automatically
during playback.
[Tape end detector works during playback due to
damaged tape.]
• Replace defective tape.
Remote control does not operate correctly.
[Remote control transmitter beam not reaching
VCR (Line Recording).]
• Ensure that remote control is pointed at VCR
(Line Recording) and transmitter beam is not
obstructed.
[Distance is too far.]
• Use remote control within 7 m of VCR (Line
Recording). If this range is not possible,
replace batteries.
[Batteries exhausted.]
• Replace batteries with UM3 or R6 type
available from your dealer. Note precautions for
replacement on page 2.
[Batteries incorrectly fitted with reversed.]
• Fit batteries correctly as shown on page 2.
RR3‑M̲AMfm.book 14 ページ ２００２年６月６日 木曜日 午後６時２１分
