Panasonic NV-SJ200A, Service Manual

Page: 6 / 71

1. Install the Cylinder Retainer so that the 2 holes on top of the
Cylinder Retainer are at right angles with the Cylinder Connection.
2. Tighten the Hex screw (C) (1.5 mm) while pressing down on top of
the Cylinder Retainer.
Fig. S4
3. Install the Cylinder Rotor Unit so that the inner hole of the
Cylinder Rotor Unit fits to the small projection (D) on top of the
Upper Cylinder.
4. Tighten 2 screws (B).
Fig. S5
5. Install the Cylinder Stator Unit so that the rear side of the Cylinder
Stator C.B.A. is parallel with the Cylinder Connection.
6. Tighten 2 screws (A).
Fig. S6
6