Since the resistance at pin 2 as well as pin 3 of IC6001 decides the model distinction data,
there is no need to set up the Model code, which is necessary in the previous models.
STEP4.LINE-IN SETTING & ACTIVATE PLUG-IN A.T.P.
(FOR OTHER THAN NV-MV40GL)
1. Press the Channel up and down keys simultaneously for more than 3 seconds, under the
condition of the no tape is in the unit.
2. Confirm that "A1" and "A2" can be displayed on the FIP by pressing the CH UP and CH
DOWN buttons.
NOTE:
If "DIRECT REC" on the OPTION setting screen is set to [ON], the input signal is fixed to
"A1", and the Channel up and down keys are not effective.
3. Disconnect the AC plug for few seconds and connect it again, and press POWER button for
turning the power to on from off to carry out the "Plug in Auto Tuner Preset".
4. Since other than the channels that can be stored by "Auto Tuning" operation are not available
yet, preset manually by consulting the note of its available TV channels of which you took
before.
NOTE:
The Factory shipping condition of OSD setting is not restored by above operation.
5. Change the OSD setting to the Factory shipping condition if necessary, by referring to Option
Setting on the Operating Instructions as shown in the following chart.
