Panasonic NV-GS80EB, Service Manual

Page: 32 / 64

10. Installation of Front P.C.B.
Install the Front P.C.B. with the 5 bosses, and tighten the
5 Screws (537).
Boss
Boss
Boss
Boss
Boss
Front P.C.B.
537
537
537
537
537
Fig. D10
11. Removal of Side R Shaft Case Unit and LCD Case A
Take care not to damage the F.P.C.
1) Open and rotate the LCD to access the 2 Screws (519).
2) Release the 8 Locking Tabs (L-1) and remove the LCD
Case A.
3) Disconnect the F.P.C. from Connector FP8101.
4) Remove the Side R Shaft Unit.
Side R Shaft
Unit
LCD (Ass'y)
FP8101
LCD Case A
LCD
Shaft
F.P.C.
Rotate to access
519
519
(L-1)
(L-1)
(L-1)
Fig. D11
12. Installation of LCD Backlight P.C.B., LCD Panel Ass'y,
LCD Shield Case Unit and LCD Case B
Use extreme care regarding LEDs when handling the LCD
Backlight P.C.B.
Install in order shown below.
1) Install the LCD Panel Ass'y onto the LCD Shield Case
Unit with the 3 Locking Tabs (L-4) while carefully
bending the LCD F.P.C. at its base so as not to damage
it.
2) Install the LCD Backlight P.C.B. onto the LCD Panel
Ass'y with the 3 Locking Tabs (L-3).
3) Install the LCD Case B with the 3 Locking Tabs (L-2).
4) Tighten the Screw (533) while keeping the LCD
Backlight P.C.B. pressed toward the left. Then, connect
the F.P.C. to Connector FP8102.
LCD
Shield
Case
LCD Panel Ass'y
LCD
F.P.C.
LCD Backlight P.C.B.
LCD Case B
(L-2)
(L-2)
(L-3)
(L-4)
(L-4)
(L-4)
(L-3)
(L-3)
FP8102
LEDs
Press
533
(L-2)
Bend
Fig. D12
32