30 cm
10 cm
5 cm
5 cm
Grounding
receptacle
Illustration for the ground
connection
Ground
wire
Installation
The top of the refrigerator and the ceiling at least 30 cm.
●
The wall and the back of the refrigerator at least 10 cm.
●
The side of the refrigerator and the wall at least 5 cm.
●
Do not
●
locate the refrigerator in a humid place as rust may form and
may cause electric leakage.
Do not
●
locate the refrigerator exposing to direct sunlight as the heat
and sunlight will increase the temperature.
Do not
●
locate the refrigerator near heat source such as cooking
stove or oven.
Do not
●
block the openings on the circumstances of the refrigerator.
The refrigerator must be located in the place where there is good air
●
circulation.
In case of placing the refrigerator on an uneven surface, adjust the
●
adjustable bolt to make the refrigerator stands stably.
When moving or shifting the refrigerator, remove ice twister, ice box, top freezer
●
case, pan water evap etc. and check to be sure that there is no water in the
refrigerator, adjust the adjustable bolt of refrigerator, then move the refrigerator
and install in the location, adjust adjustable bolt for locking.
The refrigerator LED lamp, specially designed for this refrigerator, does not function on individual
●
replacing. If you need replacement, please contact Panasonic Service Center.
If there is no grounding wiring plug in refrigerator, it should be connected with grounding connection
●
or prevent electrical hazard from electric leakage.
To bring power cord for use, pan water evap from left should be lifted up. Then bring the power cord out and
●
then insert pan water evap into the block by pressing at both the sides.
The distance from the wall is installed
Area around installed
Moving or shifting
LED lamp and Grounding
Power cord setting
For safety, the ground connection should be done
(For a refrigerator with plug (2-pin plug) without any ground wire)
The ground connection will allow prevention of danger resulted from electricity leakage.
The ground connection can be performed in 2 ways as follows:
1. In the case that the grounding receptacle having been prepared
for the socket (plug socket), connect the ground wire to the screw
used for ground connection at the bottom rear of the refrigerator
(regarding the screw used for ground connection, please notice
the symbol) as shown in the illustration
1
.
2. In the case that the socket (plug socket) having not been
provided with any grounding receptacle, connect the ground wire
to the screw at the bottom of the refrigerator, (as regards the
screw used for ground connection, please notice the symbol).
And then connect the other end to the ground rod as shown in the
illustration
2
.
Prohibited spots for ground connection
Gas pipes and water supply pipes (dangers from electric shock or explosion).
●
The ground wires of telephone cords and lightning rods (dangers from lighting).
●
5
Manul_AK-157181-EN.indd 5
Manul_AK-157181-EN.indd 5
1/27/12 9:55:32 AM
1/27/12 9:55:32 AM
