
from upper right hand corner using a flat blade screwdriver.
2. Separate door E from tabs on door A and remove door A.
3. Open Door E at the opening angle of approximately 10°(Note: The
door cannot be removed if the opening angle is greater than 10°).
4. Remove the door E from its hinges by pushing the door E upward
and out.
5. Remove door screen B from door A.
6. Remove door key and door key spring.
7. Place the door's lower hinge pin into the bottom hinge hole.
8. Use your left index finger to support the door's lower hinge pin
while guiding the door's upper hinge pin into the top hinge hole.
9. Lower your finger to seat the door onto the hinges.
10. Replace other components.
NOTE:
Door alignment is crucial. If door is misaligned, apply pressure until
alignment is achieved.
NOTE:
After replacement of the defective component parts of the door,
reassemble, install, and perform microwave leakage test.
16
Summary of Contents for NN-V653WF
