6
Power Supply
1. A short power-supply cord is provided to reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
2. Longer cord sets or extension cords may be used if care is exercised in their use.
Do
not
let cord hang over edge of a table or counter.
3. If a long cord or extension cord is used,
• The marked electrical rating of the cord set or extension cord should be at least as
great as the electrical rating of the appliance.
• The extension cord must be a grounding-type 3-wire cord.
• The longer cord should be arranged so that it will not drape over the
counter top or tabletop where it can be pulled on by children or tripped
over accidentally.
Wiring Requirements
1. The oven must be operated on a SEPARATE CIRCUIT. No other appliance should
share the circuit with the microwave oven. If it does, the branch circuit fuse may blow or
the circuit breaker may trip.
2. The oven must be plugged into a 15 AMP or 20 AMP, 120 VOLT, 60 Hz GROUNDED
OUTLET. Where a standard two-prong outlet is encountered, it is the personal respon-
sibility and obligation of the consumer to have it replaced with a properly grounded
three-prong outlet.
3. The VOLTAGE used must be the same as specified on this microwave oven (120 V, 60
Hz). Using a higher voltage is dangerous and may result in a fire or oven damage.
Using a lower voltage will cause slow cooking. Panasonic is NOT responsible for any
damages resulting from the use of the oven with any voltage other than specified.
TV / Radio Interference
1. Operation of the microwave oven may cause interference to your radio, TV or similar
equipment.
2. When there is interference, it may be reduced or eliminated by taking the following
measures:
(a) Place the radio, TV, etc. away from the microwave oven as far as possible.
(b) Use a properly installed antenna to obtain stronger signal reception.
(c) Clean door and sealing surfaces of the oven. (See Care and Cleaning of Your
Microwave Oven)
INSTALLATION AND GROUNDING
INSTRUCTIONS
(continued)
IP2881_39R20CP_06_100108 2010.1.8 4:58 PM Page 8