Panasonic NN-S335WM, Service Manual

Page: 12 / 27

7.5. Door assembly
1. Remove door C from door E by carefully pulling outward
starting from upper right hand corner using a flat blade
screwdriver.
2. Separate door E from tabs on door A and remove door A.
3. Remove door screen B from door A.
4. Remove handle spring which hitching door handle,
seperate door handle from door A by pulling outward door
handle slightly, moving it towards the side of door A and
out.
5. Open Door E at the opening angle of approximately
10°(Note: The door cannot be removed if the opening
angle is greater than 10°).
6. Remove the door E from its hinges by pushing the door E´s
bottom upward and out.
7. Remove door key and door key spring from door E.
8. Replace other components.
NOTE:
Door alignment is crucial. If door is misaligned, apply
pressure until alignment is achieved.
NOTE:
After replacement of the defective component parts of
the door, reassemble, and perform microwave leakage
test.
7.6. Turntable motor
1. Remove the motor cover by breaking off at the 4 spots
indicated by arrows with a cutter or the like.
NOTE:
After breaking off the motor cover, make sure that
cut-off portions are properly trimmed off or bent to
inside so that no sharp edges will be exposed to the
outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing 1 screw.
NOTE:
After reinstalling the new turntable motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180°, tucking the 2 tabs
under the base into the 2 provided slots, then screw
the single tab to the base using a screw.
12
NN-S335BF / NN-S335WF / NN-S335WM /