4. Disconnect connector CN701 from H.V. Inverter board.
5. Remove 6 screws holding D.P.C. board on escutcheon
base.
6. Separate D.P.C board from tabs on the escutcheon base
and remove D.P.C board.
To replace membrane key board
7. Remove 1 screw.
8. Use tools such as kinfe etc. to lift the edge of membrane
sheet and peel off escutcheon sheet & key board
membrane completely from escutcheon base.
NOTE:
a. The membrane key board is attached to the
escutcheon base with double faced adhesive tape.
Therefore, applying hot air such as using a hair dryer
is recommended for smoother removal.
b. When installing the new key board membrane, make
sure that the surface of escutcheon base is clean to
prevent a malfunction or shorted contacts.
12
NN-GF560M
Summary of Contents for NN-GF560M
