– 29 –
5. Touch Prog Pad.
This completes the procedure to program time between cleaning of the Air Filter.
6. After 3 seconds, “0” will appear in the Digital Display Window. The oven is now
ready for use.
Note:
When “FILt” sign appears in Digital Display Window, remove the Air Filter and
clean it.
Touch Stop/Reset Pad for 2 seconds to clear the display.
to display the filter cleaning alarm counter
1. Open the door and leave it open.
2. While touching Start Pad, touch Number Pad “5”.
3. The cumulative total cooking time starts over and is displayed after it is cleared.
After 3 seconds, “0” will appear in the Digital Display Window.
N.b.
If the oven cuts out after short operation, check the Air Filter is clean before
calling an engineer.
O. Oven lamp
(the oven can not be programmed until the program lock feature is deactivated.)
Oven lamp settings when the door is open
to turn Oven lamp settings OFF
1. Open the door and leave it open.
The oven lamp will turn on, and “0” will appear.
2. While touching Start Pad, touch Number Pad “9”.
“PROG” will start to blink. The previously set Oven Lamp settings are displayed.
3. Touch Start Pad.
Note:
“on” “oFF” “on” is repeated each time the Pad is touched.
4. Touch Prog Pad.
“PROG” will stop blinking, and the Oven Lamp settings will appear for 3 seconds.
Then “0” will appear.
To proceed to Step 5, touch Start Pad before “0” is displayed after Step 4.
(Continued on next page.)
how to Operate NE-1853
