– 17 –
M. To Select Beep Tone Options
(The oven can not be programmed until the program lock feature is deactivated.)
The beep tone can be set for loudness—(4 Levels), length of tone—(3 Options), pitch of tone—(3 Options)
and pitch of filter cleaning alarm—(3 Options). You can select the combination of loudness, length and pitch
that best suits your needs.
The beep tone is set at the factory for the loudest level (#3), for 3 beeps and for normal pitch.
To Select Loudness Level
1. Make sure the oven is plugged into a properly earthed electrical outlet.
2. Open the door and leave it open.
The oven lamp will turn on. “0” will appear in the display.
3. Touch Prog Pad first and then touch Start Pad.
“3 bEEP” and pattern of buzzer sound settings indicator “1” will appear in the
Digital Display Window and “PROG” will blink.
4. Select the desired sound loudness level by touching Start Pad.
Repeated touching of Start Pad will lower the loudness of the tone all the way to
silent. The tone will sound at its loudness level and the Digital Display Window
will display loudness level in digits (3 to 0—loud to silent) followed by the word
“bEEP”.
[Example]: 3 bEEP—Loudest
1 bEEP—Low
2 bEEP—Mid
0 bEEP—Silent
5. Touch Prog Pad again, “PROG” will stop blinking, and the set loudness of beep
tone will appear for 3 seconds. Then “0” will appear.
To proceed to set length of beep tone, touch Start Pad before “0” is displayed after
Step 5.
To Select Length of Tone
The length of beep tone at the end of heating cycle there are 3 options.
1st. 3 beeps (Factory Setting)
2nd. Short beeps for 60 seconds
3rd. “Beep” sounds for 5 seconds, and then 3 beeps sound 30 seconds later and
again 60 seconds later. (Buzzer reminder functions to prevent food forgotten
in the oven.)
6. Within 3 seconds after touching Prog Pad at Step 5, touch Start Pad.
A. “PROG” will blink.
B. Current length of beep tone will be displayed.
C. The display changes to 1st, 2nd, and 3rd each time the Start Pad is touched
and the settings change.
7. When the desired length of tone has been selected, touch Prog Pad again.
“PROG” will stop blinking, and the set length of tone at the end of heating cycle
will appear for 3 seconds. Then “0” will appear.
To proceed to set pitch of beep tone, touch Start Pad before “0” is displayed after
Step 7.
(Continued on next page.)
